Additional information for parameter "Run Check Delay"

Additional information for parameter "Run Check Delay"

P12.33 Run check delay


One of the selectable functions for a digital input is checking a feedback signal of a motor relay.

P12.33 determines the time the DI has to change status.


    • Related Articles

    • Additional information for parameter "Limit schedule functions"

      P12.34 Limit schedule functions This parameter can limit the selection of actions for the run schedule. When switched ON the actions are limited to use default PH/PL, use schedule PH/PL and go to standby. When switched OFF, 3 more actions are ...

    • Additional information for parameter "Restart Reminder"

      P12.24 Restart Reminder Restart reminder is a selection for information at power up. If at the moment of power down, there is an active immediate shutdown condition, there are 3 ways of starting up. You switch this selection OFF and nothing happens. ...

    • Additional information for parameter "P switch"

      P12.35 P Switch low This parameter is related to the relay function PRESS Switch NO/NC. When relay function is set as PRESS switch NO, the relay will be active when COMP out press ≥ P switch high and will be deactivate when COMP out press ≤ P switch ...

    • Additional information for parameter "Resume DI start"

      P12.32 Resume DI start Resume DI start observes the condition of the DI associated with DI start after a power failure. When switched on the controller will generate an artificial contact open/close cycle in order to remote start the controller when ...

    • Creating new parameter configuration files and upload compressor tables

      This video explains how to create new parameter configuration files and how to upload compressor tables to your Form Q1 or Q2 controller. RUN VIDEO HERE or download for local playback! Applicable to: 'FORM' Q1 'FORM' Q2 To follow this video tutorial, ...