Additional information for parameter "Limit schedule functions"

Additional information for parameter "Limit schedule functions"

P12.34 Limit schedule functions


This parameter can limit the selection of actions for the run schedule.

When switched ON the actions are limited to use default PH/PL, use schedule PH/PL and go to standby.

When switched OFF, 3 more actions are available in the action list: run default PH/PL, run schedule PH/PL and device stop.

For the 3 first ones to be able to work, the user must start the machine first. Here starting and stopping the machine is left to the operator. The additional actions will actually start and stop the machine as scheduled.


    • Related Articles

    • Additional information for parameter "Run Check Delay"

      P12.33 Run check delay One of the selectable functions for a digital input is checking a feedback signal of a motor relay. P12.33 determines the time the DI has to change status.

    • Additional information for parameter "P switch"

      P12.35 P Switch low This parameter is related to the relay function PRESS Switch NO/NC. When relay function is set as PRESS switch NO, the relay will be active when COMP out press ≥ P switch high and will be deactivate when COMP out press ≤ P switch ...

    • Additional information for parameter "Restart Reminder"

      P12.24 Restart Reminder Restart reminder is a selection for information at power up. If at the moment of power down, there is an active immediate shutdown condition, there are 3 ways of starting up. You switch this selection OFF and nothing happens. ...

    • Additional information for parameter "Resume DI start"

      P12.32 Resume DI start Resume DI start observes the condition of the DI associated with DI start after a power failure. When switched on the controller will generate an artificial contact open/close cycle in order to remote start the controller when ...

    • CS Units explained (parameter configuration)

      Below you can find a table that describes certain units that are not always easy to interpret. Often, an example is used for clarification. Please note that the list below is not controller type based. It is an assembly of all available units in CS. ...